wist niet waar dit moest

heb al 2 keer een bsod gekregen met de codes: 0x000000f4 (0x00000003,0x896637e0,0x89663954,0x805d1142

lees hier even:
SYMPTOMS
A computer that is running Microsoft Windows XP or a later operating system stops responding during resume from standby, and you receive the following KERNEL_DATA_INPAGE_ERROR stop error message:
0x0000007a (e163a3e4,c000000e,bf8e9313,0697f860)
or
0x000000F4 (0x00000003, Parameter2, Parameter3, Parameter4)
Note Parameter2, Parameter3, and Parameter4 in the stop error may vary.

This problem occurs on a computer in which Windows XP or a later operating system is installed on a hard disk that is configured as a subordinate and no other device is connected to the same IDE controller channel (primary or secondary).
Back to the top

CAUSE
This behavior may occur when you use Windows XP or a later operating system with some motherboards. Microsoft is researching this problem and will post more information in this article when the information becomes available.
Back to the top

RESOLUTION
To resolve this behavior, use one of the following methods:• For Parallel Advanced Technology Attachment (PATA) hard disks, configure your disk drive as master only. For Serial Advanced Technology Attachment (SATA) hard disks, connect the hard disk cable to a master channel SATA connector on the motherboard.
• Connect another device as a master, such as another disk drive or a CD drive or DVD drive.
• Change your PATA and SATA IDE cable even if the cable does not appear worn.
• Install Windows on a new hard disk because it is possible that your hard disk or your Windows installation may be corrupted.

Back to the top

MORE INFORMATION
Steps to reproduce the behavior
1. For PATA hard disks, set the hard disk jumper to slave mode. For SATA hard disks, connect the hard disk cable to a slave channel SATA connector on the motherboard.
2. In BIOS power management, set BIOS to S1 or S3 (STR).
3. Install Windows XP Professional with Service Pack 1 or Service Pack 2.
4. Restart the computer.
5. Set the computer to Standby.
6. Try to resume the system. The system stops responding.


http://support.microsoft.com/default.aspx?scid=kb;en-us;330100

kvind het wel raar mijn configuratie is nu al lang zo en krijg dit nu pas

Mss is je HD niet 100% meer. Check hem eens met chkdsk of een tool van de fabrikant.

de schijf is nog 60% dus dat zal het niet zijn

maar daarjuist was het tijden counterstrike en een keer in idle

Met "niet 100%" bedoelde ik dus dat ie niet helemaal meer in orde is. Ergens wat fouten of zo. :)

is slechts 2dagen geledne opnieuw geinstalleerd
mss ligt het daaraan

who knows. Met pc's weet je nooit he.

ik heb kokki bedankt voor de hulp
heb de instructies gedaan en zag dat de jumper omgekeerd zat dus geen contact

deze mag op slot